#Duct seal putty driver#
#Duct seal putty download#

Rotate one plug 90 degrees, and place it in the remaining bottom right side corner. All four plugs should be parallel, and touching. Repeat this for the opposite side of the bottom. Use that paper to press the putty on the bottom, securing it in place. Position the plug in one corner, and tight against one side of the basin bottom. Remove the plastic protective cover from one plug of the Duct Seal putty. Hand tighten the machine nuts on each of the machine screws, tighten by hand, then use the pliers to tighten the nuts until they are fully seated. Place a flat washer on the machine screws, and using the flat head screw driver, drive them into place. Drill the four holes using the electric drill with the 1/8 in. Position the Metal Door Pull in a place that provides the best position to carry the finished pellet trap. Tighten by hand, then use the pliers to tighten until the wire nuts are fully seated. Cap the wood screws tip that extends outside the basin with the wire nuts.

#Duct seal putty driver#

Use the Electric Drill with the Phillips head driver bit to drive the wood screws through the clipboard top and attach it to the Basin. Center the top of the clipboard inside the top edge of the basin and using the pencil, scribe two dots where the wood screw will be drilled through to attach the clip. E.Place the basin on its side, so that the outlets form a РІР‚СљTРІР‚Сњ. Using the miter saw, cut that line, save the bottom of the clipboard. Scribe a pencil line parallel to the top edge of the clipboard at 2 in. Attach the two universal outlets to the outside of the basin per Kit instructions. Remove the two screws from the Polyolefin top grate of the kit, and the top grate. This design is based on the one created by Joe Matusic, MD which has been used for years by hundreds of serious air gunners. This avoids pellets bouncing out of the trap onto the floor, where they could present a safety risk to small children and pets. 22 caliber air rifles and catches them safely in its huge internal pellet reservoir. This trap stops pellets even from high-powered. The duct seal adheres to the back of the trap and stays in place through continued use.

#Duct seal putty download#

You have no additional costs with this pellet trap once you have the trap and Duct Seal! There is no need to continually buy targets, cardboard backers and replacement impact putty, just download your targets and print them at home using your own printer. So you can shoot air guns indoors or out without disturbing family or neighbors! This pellet trap is easy to set-up and fast to use. Strongly-constructed, it stops and catches pellets fired from your air guns without the noisy, annoying clang of a metal trap. This 'Silent' Pellet Trap is beautiful, durable, functional and long-lasting.